Short frame carrier
Shortcut frameYou can also tour with
I haven't gone touring since I changed to short fenders...
I want to cut the fender, but I can't go touring...
For such a custom sportster
2023.07.28 Patent pending
Note: Installation conditions
There must be a first "bolt hole" from the suspension bolt
set content
Thick iron and powder coating allows for safe and long-term use
(*The photo isNot yetPainting: To make it easier to see)
set content
-
Top plate x 1: Iron t2.3
-
Top plate support x 1: Iron T2.3
-
Stand left and right: Iron t3.2
-
Base left and right: Iron/welded t3.2
-
Ships after powder coating
-
Screws (stainless steel)
Those who have blinkers installed in the hall
[Needs to be relocated]EssentialNana]
In that case, when using the turn signal stay for this hole,
To protect body partsof"WaShear x 2”but
I will enter
"Genuine bolt (approx. 45mm)"
At the last minute
You will need a 50mm bolt.
Using genuine bolts: When inserting 2 washers
The length is just within the acceptable range
Using genuine bolts: with turn signal stay installed
+If you insert 2 washers, the length is not enough
SS.Daze turn signal stay
-
Iron t2.3 weldingMatte blackInstallationM8 hole turn signal M8
-
Design that makes wiring difficult to see
-
¥8,800
Hexagonal 500mm bolt/locking flange nut
-
M8 hex bolts (50mm) ¥110×2=¥220
-
M8 flange nut ¥110×2=¥220 Set total ¥440
